Zahle 30 Tage später mit Paypal
Kaufe auf Rechnung
Erstklassiger Support
Weltweiter Versand
Couldn't load pickup availability
Same content, same power, new packaging
Who has to attach which license plate where is regulated in the Vehicle Registration Ordinance (FZV). According to Section 10 Paragraph 5 of the FZV, license plates must be present and firmly attached to the front and rear of the vehicle. Neither the term “fixed” nor the type of fastening is defined in more detail. It is therefore not mandatory that the license plate must be attached to the car with screws. The FZV also does not rule out attaching the license plate with magnets.
In any case, it is important to carefully follow the instructions for attaching license plates with magnets. Carefully attach the specified number of magnets to the bumper and license plate. Under no circumstances should you use fewer magnets than specified or even use a set to attach a license plate with magnets for two license plates. While driving, the license plate is exposed to far greater stress and forces than when standing. Anything stuck in the parking lot can easily fly away while driving if you reduce the number of magnets.
The magnetic license plate holder contains a total of 20 magnets for one license plate. 10 magnets are attached to the inside of the bumper and 10 magnets to the back of the license plate so that the license plate has a firm hold even at high speeds.
(Text of the law: https://www.gesetze-im-internet.de/fzv_2011/__10.html?fbclid=IwAR2UF1si0GxwgntMoyOJiKR9jHL-Ow8W609XyGqwXh_4yqmOYVBstFDSzDk )
Fastening instructions
Please be sure to follow the enclosed safety instructions!
Gluing the magnets to the license plate:
When sticking the magnets on the license plate, please pay attention to the magnets
not in the embossing (aluminum license plate) or on the rivets (3D license plate)
to stick. The magnet must be stuck on a flat surface, otherwise
full adhesion cannot be achieved.
MagNFix attachment step by step:
1. Position magnets on the inside and outside of the bumper and
Test positioning. Absolutely on the mutual attraction of the
Pay attention to magnets!
2. Mark the position of the outer magnets on the license plate and the
Thoroughly clean/degrease the affected areas with the alcohol swab.
3. Remove the protective film from the magnets and stick it on the license plate. The
Press the magnets firmly onto the license plate.
4. Glue the license plate fleece onto the license plate, ideally on the side
Start at the top of the license plate. License plate fleece only at the top
Stick it in place, then peel it off completely and smooth it down
stick on. (An air cushion around the magnets is desired and normal here)
5. Mark the position of the inner magnets on the bumper and
Thoroughly clean/degrease the affected areas with the alcohol swab.
6. Remove the protective film from the magnets and stick it on the bumper. The
Press magnets firmly onto the bumper.
7. Glue foil cuts to the magnets. For this purpose the foil on the magnet
Apply and then apply from top to bottom. Here too is one
Air pocket around the magnet is normal. The magnets are through the foil
protected from incoming water and dirt.