MAGNFIX magnet license plate holder
Scope of delivery:
10 pairs of magnets (20 magnets with opposite polarity):
• 10 magnets for the number plate
• 10 magnets for the bumper
1 Velcro in the size 520 x 100 mm, can be used for the license plate length
be cropped
2 alcohol wipes for degreasing
Matching pieces of foil to cover the magnets behind the bumper
mounting instructions
Please be sure to observe the enclosed safety instructions!
Gluing the magnets to the license plate:
When sticking the magnets on the license plate, please make sure that the magnets
not in the embossing (aluminum license plate) or on the rivets (3D license plate)
to glue. The magnet must be stuck on a flat surface, otherwise
the full adhesive force cannot be achieved.
Processing temperature of the adhesive tape:
The optimum processing temperature for the adhesive tape is at least 20°C.
The final adhesive strength is most quickly increased by gentle heating up to 65°C (e.g. with
a hair dryer) within 1 hour. Please do not stress the tape before and
observe the recommended processing temperature, otherwise the full
adhesive force cannot be achieved.
Mutual attraction of the magnets:
Please make sure before fixing the mutual
Note the attraction of the magnets and before
Test sticking. The pairs of magnets must be as in the
adjacent picture can be formed.
Cleaning the license plate fleece:
Regular cleaning of the license plate fleece prevents scratches on the paintwork
in front.
MagNFix in the car wash:
Please be sure to remove the license plates before washing in the car wash.
Otherwise, the washing brushes and the water pressure can loosen the number plates.
Remove license plate:
Rotate the license plates while pulling them. So when removing the
Plate a bend avoided.
MagNFix attachment step by step:
1. Position magnets on the inside and outside of the bumper and
test positioning. Necessarily on the mutual attraction of
Watch out for magnets!
2. Mark the position of the outer magnets on the license plate and the
Thoroughly clean / degrease the affected areas with the alcohol swab.
3. Remove the protective film from the magnets and stick it on the license plate. the
Press magnets firmly onto license plate.
4. Glue the license plate fleece onto the license plate, preferably on the
Start top of mark. License plate fleece only at the top
stick it in place, then pull it off completely and smear it downwards
stick. (An air cushion around the magnets is wanted and normal here)
5. Mark the position of the inner magnets on the bumper and the
Thoroughly clean / degrease the affected areas with the alcohol swab.
6. Remove the protective foil from the magnets and stick it on the bumper. the
Press the magnets firmly onto the bumper.
7. Glue the foil cuts to the magnets. For this purpose the foil on the magnet
place and then press down from top to bottom. Also here is one
Air pocket around the magnet is normal. The magnets are through the foil
protected from ingress of water and dirt.
Legal Notice
Use of MagNFix for license plate attachment:
Excerpt from the Ordinance on the Registration of Vehicles
Road traffic (vehicle registration regulation - FZV) § 10 design and
Attachment of license plates in Germany:
"[...] (5) License plates must be on the front and rear of the motor vehicle
be present and firmly attached. In the case of variable license plates within the meaning of Section 8
Paragraph 1a are the common indicator part and the vehicle-related part
to be attached firmly. In the case of single-axle tractors, attachment is sufficient
the front, in the case of trailers and in the case of motorcycles, attachment to their
Back."
There is therefore no ban on attaching the license plates with magnets.
Other license plate holders also have no E number and one
Disassembly of the number plate is also possible without tools for most models
easily possible.
Nevertheless, we cannot guarantee that it will be used on the road.